Inverting remote on-off cable Pulleys

Inverting remote on-off cable PulleysShipping, taxes, and discounts will be calculated at checkout. The Victron Energy Inverting remote on off cable is intended for products which require active pull down of the remote control terminal to switch on, while the source signal turns high when switch on is required. Use this cable to connect the (discontinued) Phoenix Inverter 12 180, 24 180, 12 350 or 24 350 to a VE. Bus BMS or a BlueSolar MPPT Charger that features a load output: VE. Bus

Victron Energy Male to Female circular 3 pole connector 1 m cable (bag of 2)

Manual: Digital 200/200A Multi Control GX

the Victron Quattro takes over the supply to the connected loads

IP43 protection

Use this cable to connect the following products to the VE

The Skylla Control allows you to alter the charge current and see the system status on the Skylla-TG Chargers

The BMS will:

This product is for 120V / 60Hz systems

Non-isolated

and disconnects when the voltage decreases below float level (indicating that one or more batteries are being discharged)

Smart Battery Sense

Image shows a similar product from the same series