HEEL SHROUD LARGE Boss

HEEL SHROUD LARGE BossThis is a heavy duty large, weld on, bucket heel shroud. It is roughly 1" thick, the legs of the angle are 8" & 6" and it is about 7" wide. Also known as 138 6551. This is mostly used on large excavator buckets however some large loader buckets can benefit from the wear protection as well. If you are loading ripping rock all day long this is a must.

CHOCKY BAR 1

This item is a box qty of 35 heavy duty standard weld on blocks for 19mm shaft diameter rotating milling bits

This is a 40s general purpose bucket tooth

This steel bucket pin shim is for a pin with an outer diameter of 110 mm

This is a genuine ESCO Ultralok weld on adapter with industry standard part number of 5856-u40

This is a 15 ton weld on bucket hook with the spring loaded safety latch

This is a 27lk Vkit lock set for use with 27syl series bucket teeth

1/2" x2" hex cap bolts and nuts

This bolt on Cutting Edge has an industry standard part number of AT314220 and has 3 bolt holes

This is a p290 flex pin for use with x290 series teeth

This is a genuine ESCO Ultralok u25p pointed bucket tooth

This bolt on side cutter (can be welded on) is used on excavator buckets and has an industry standard part number of 7y0357 also known as 8J9615