Ripper - Bakelite gavitt

Ripper - Bakelite gavittPlease note that this pickguard will only fit genuine 1973 1983 Gibson Ripper basses. The earliest Gibson Ripper basses (1973 1975) do not have pickup mounting holes. This pickguard will not fit an Epiphone manufactured instrument even it does have the Gibson name on the truss rod cover. Made from genuine paper phenolic bakelite measuring 2mm thick and does not have any outer bevel around the edge of the pickguard.

Will fit headstock holes that are drilled out to 10mm diameter

Neck plate

This replacement pickguard is made specifically for the Fender Pawn Shop 72 GuitarMade from a single ply off-white parchment material measuring 1

 Mounting screws

Smooth Top

To eliminate this noise

It required a complete re-think of the classic saddles and the 6 hole knife edge

and had to be so thick that it would stay where you put it (that means in the nut slots

This is not a replacement part for American Standard or American Deluxe bass guitars

393 N/A Approx In 2 29/32 3/32 3/8 N/A Millimeters

with 5/16-24 thread on the Stud Posts

These professional files help you get the job done properly and efficiently